Определяем
Сегодня покупают
ГлавнаяСправочникиDellSC Series
Dell Storage Center SC100 and SC120 Expansion Enclosure: руководство по обслуживанию
← Вернуться назад
Нужна помощь с конфигурацией?
Пришлите SKU, спецификацию или список требований. Специалист Apltech проверит совместимость компонентов и найдёт актуальные артикулы
Получить консультацию →

Dell Storage Center SC100 and SC120 Expansion Enclosure: руководство по обслуживанию

Technical Specifications

The technical specifications of the SC100/SC120 expansion enclosures are displayed in the following tables.

Drives
SAS hard drives SC100 : Up to 12 3.5-inch SAS hot-swappable hard drives (6.0 Gbps)

SC120 : Up to 24 2.5-inch SAS hot-swappable hard drives (6.0 Gbps)

Enclosure Management Modules (EMMs)
EMMs Two hot-swappable IO modules
Connectivity
Configurations Storage Center supports up to 168 drives in one redundant-path SAS chain
  • An SCv2000 supports up to 13 SC100 expansion enclosures or 6 SC120 expansion enclosures
  • An SCv2020 supports up to 12 SC100 expansion enclosures or 6 SC120 expansion enclosures
Redundant Array of Independent Disks (RAID)
Storage System SCv2000/SCv2020
Management RAID management using Dell Storage Client 2015 R1
Back-Plane Board
Connectors SC100 : 12 SAS hard-drive connectors

SC120 : 24 SAS hard-drive connectors

  • Two power supply/cooling fan module connectors
  • Two sets of EMM connectors
  • One control panel connector for front LEDs
Sensors Two temperature sensors
Back-Panel Connectors (per EMM)
SAS connectors SAS A and B connectors for connecting an expansion enclosure to a storage system.
  • NOTE: SAS connectors are SFF-8086/SFF-8088 compliant
Serial connector One 6-pin UART mini-DIN connector
  • NOTE: Not for customer use.
LED Indicators
Front panel
  • One two-color LED indicator for system status
  • One single-color LED indicators for power status
Hard-drive carrier
  • One single-color activity LED
  • One two-color LED status indicator per drive
EMM Three two-color LED status indicators, one each for the two EMM SAS ports and one for the EMM status
Power supply/cooling fan Three LED status indicators for power supply status, power supply/cooling fan fault status, and AC status
Power Supplies
AC power supply (per power supply)
Wattage 700 W
Voltage 100–240 VAC
Frequency 50/60 Hz
Amperage 8.6 A at 100 V, 4.3 A at 250 V
Heat dissipation SC100 : 2,389 BTU/hr (at 700W)  1,536 BTU/hr Max

SC120 : 2,389 BTU/hr (at 700W) 1,621 BTU/hr Max

Maximum inrush current Under typical line conditions and over the entire system ambient operating range, the inrush current may reach 55 A per power supply for 10 ms or less
Available Hard Drive Power (per Slot)
Supported hard drive power consumption (continuous) SC100 : Up to 1.16 A at +5 V, up to 1.6 A at +12 V

SC120 : Up to 1.2 A at +5 V, up to 0.5 A at +12 V

EMM Power (per Slot)
Maximum power consumed by EMM SC100 : 11 W at +12 V

SC120 : 14 W at +12 V

Maximum available power 100 W at +12 V
Maximum available power 1 W at +5 V (standby)
Physical
Height 8.7 cm (3.43 in.)
Width 48.2 cm (18.98 in.)
Depth SC100 : 59.4 cm (23.39 in.)

SC120 : 54.1 cm (21.3 in.)

Weight (maximum configuration) SC100 : 28.39 kg (62.6 lb)

SC120 : 23.31 kg (51 lb)

Weight without drives SC100 : 8.84 kg (19.5 lb)

SC120 : 8.61 kg (19 lb)

Environmental
  • NOTE: For additional information about environmental measurements for specific configurations, see dell.com/environmental_datasheets.
Temperature
Operating 5° C to 40°C (41° F to 104°F) with a maximum temperature gradation of 10°C per hour
  • NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1°F per 550 ft.
Storage –40° C to 65°C (–40° F to 149°F) with a maximum temperature gradation of 20°C per hour
Relative humidity
Operating 20% to 80% (noncondensing) with a maximum humidity gradation of 10% per hour
Storage 5% to 95% (noncondensing)
Maximum vibration
Operating 0.26 G at 5–350 Hz for 15 min
Storage 1.88 G at 10–500 Hz for 15 min
Maximum shock
Operating Half-sine shock 31 G +/- 5% with a pulse duration of 2.6 ms +/- 10% (in operational orientations only)
Storage
  • Half-sine shock 71 G +/- 5% with a pulse duration of 2 ms +/- 10% (all sides)
  • Square wave shock 27 G with a velocity change of 235 in. per sec (all sides)
Altitude
Operating –16 m to 3048 m (–50 ft to 10,000 ft)
  • NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1°F per 550 ft.
Storage –16 m to 10,600 m (–50 ft to 35,000 ft)
Airborne Contaminant Level
Class G2 or lower as defined by ISA-S71.04- 1985